Products Quality Standard
 2) Rear Corner Post-inner for Container

 

DIMENSIONS AND QUALITY RULES OF CONTAINER CORNER
 Chemical Composition(%)
 Machinical Performance
 Technical Requirements
(1)Container corner casting should be in accordance with the regulation of ISO1161 and YLQ_001 specification.
(2)For machining faces:
   a. Two relatively parallel faces:
    Tangent of angle of the two faces is less than 0.3mm.
   b. Two vertical faces:
    Cotangent of angle of two faces is less than 0.3mm.
   c. Free of obvious tool bruises.
(3)Not indicated fillet radius R=3 mm.
(4)The thickness of holeless wall should be more than 9mm.
(5)Corner casting must be cleared up without sand, sharp angle, and rags.
(6)Installation position number,the Company's mark and heat number shall be cast on face A.
2003 ©copyright JiangMen Xinhui YILI Sectionsteel CO.LTD & YILI container Fittings co.ltd. All rights reserved.